The short version of Thymosin beta-4 fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Lyophilized peptide arrives as a dry cake that should stay sealed until use. Reconstitution is generally performed with sterile water or a buffered solution, and the resulting liquid should be handled gently to limit mechanical stress. Repeated freeze-thaw cycles are widely described as harmful to short peptides, so dividing a reconstituted batch into single-use portions is a common practice. Laboratories also record the solvent, concentration, and date of preparation on the vial label to keep later measurements traceable.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
Thymosin beta-4 contains 43 amino acids and has a reported molecular mass near 4963 Da. The short fragment most often associated with the TB-500 label, an acetylated chain beginning LKKTETQ, has a reported mass near 889 Da, so the two are easily separated in analytical work. Mass spectrometry and amino acid analysis can confirm which material is present in a given sample. Statements treating TB-500 and thymosin beta-4 as interchangeable are therefore imprecise, even though the two appear together in much of the same literature.
Interest in the compound comes largely from studies of the parent protein, which participates in actin sequestration, cell migration and tissue repair processes. Whether a short fragment reproduces those activities is a separate question that remains open in the published record. Many summaries describe mechanisms by analogy to thymosin beta-4 rather than from direct measurements on the fragment. Claims about activity should be treated as provisional unless a cited study specifies the exact peptide, its purity and the assay used.
TB-500 is a laboratory label applied to a short synthetic peptide that is widely described as a fragment of thymosin beta-4, an actin-binding protein present in most mammalian cells. Suppliers and review articles usually present TB-500 as the N-terminal region of that protein, but the exact sequence attached to the name is not consistent across sources. Some product descriptions list a seven-residue chain; others use the label loosely for the parent protein itself. Because of that variation, any technical discussion of TB-500 needs to state which sequence is meant.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
The Bjelke-Petersen Ministry was a ministry of the Government of Queensland and was led by Premier Joh Bjelke-Petersen, who led the Country Party and its successor, the National Party. It succeeded the Chalk Ministry on 8 August 1968 as part of a series of events following the death of former Premier Jack Pizzey on 31 July. It was succeeded by the Ahern Ministry on 1 December 1987 following Bjelke-Petersen's resignation as Premier. All lists below are ordered by decreasing seniority within the Cabinet, as indicated by the Government Gazette and the Hansard index. Blue entries indicate members of the Liberal Party, while non-shaded entries indicate members of the Country or National Party.
== Historical recipes == Gochujang ingredients reported in Jeungbo sallim gyeongje were 18 litres (19 US quarts) of powdered and sieved meju (fermented soybeans), 540 mL (18+1⁄2 US fl oz) of chili powder, and 1.8 L (1+7⁄8 U.S. qt) of glutinous rice flour, as well as soup soy sauce for adjusting the consistency. The gochujang recipe in Gyuhap chongseo, an 1809 cookbook, uses powdered meju made from 18 L (19 US qt) of soybeans and 3.6 L (3+3⁄4 US qt) of glutinous rice, then adding 900–1,260 mL (30+1⁄2–42+1⁄2 US fl oz) of chili powder and bap made from 3.6 L (3.8 US qt) of glutinous rice.
== Biochemistry == Tetrodotoxin binds to what is known as site 1 of the fast voltage-gated sodium channel. Site 1 is located at the extracellular pore opening of the ion channel. Any molecule bound to this site will block sodium ions from going into the nerve cell through this channel (which is ultimately necessary for nerve conduction). Saxitoxin, neosaxitoxin, and several of the conotoxins also bind the same site. The use of this toxin as a biochemical probe has elucidated two distinct types of voltage-gated sodium channels (VGSCs) present in mammals: tetrodotoxin-sensitive voltage-gated sodium channels (TTX-s Na+ channels) and tetrodotoxin-resistant voltage-gated sodium channels (TTX-r Na+ channels). Tetrodotoxin inhibits TTX-s Na+ channels at concentrations of around 1–10 nM, whereas micromolar concentrations of tetrodotoxin are required to inhibit TTX-r Na+ channels. Nerve cells containing TTX-r Na+ channels are located primarily in cardiac tissue, while nerve cells containing TTX-s Na+ channels dominate the rest of the body. TTX and its analogs have historically been important agents for use as chemical tool compounds, for use in channel characterization and in fundamental studies of channel function. The prevalence of TTX-s Na+ channels in the central nervous system makes tetrodotoxin a valuable agent for the silencing of neural activity within a cell culture.
Sources: en.wikipedia.org
=== Centrally active === These drugs are used mainly as antidotes to reverse opioid overdose and in the treatment of alcohol dependence and opioid dependence (by blocking the effects, namely euphoria, of opioids so as to discourage abuse).
Cipaglucosidase alfa, sold under the brand name Pombiliti, and used in combination with miglustat, is a medication used for the treatment of glycogen storage disease type II (Pompe disease). Cipaglucosidase alfa is a recombinant human acid α-glucosidase enzyme replacement therapy that provides an exogenous source of acid α-glucosidase. The most common side effects include chills, dizziness, flushing, sleepiness, chest discomfort, cough, swelling at the infusion site and pain. The most common side effects of cipaglucosidase alfa in combination with miglustat are headache, diarrhea, fatigue, nausea, abdominal pain, and fever. Cipaglucosidase alfa was approved for medical use in the European Union in March 2023, and in the United States in September 2023.
A 2017 report conducted by Beijing LGBT Center and Peking University showed that out of 1279 of its respondents who wanted to receive hormone treatment, 71% of them felt that it was "difficult", "very difficult", or "virtually impossible" to acquire safe and reliable information about gender affirming medications and receive hormonal replacement therapy with the guidance of a doctor. As a result, 66% of the respondents chose "online" and 51% chose "friends" as one of their sources for hormone replacement therapy medications. Gender reassignment surgeries were reported to be similarly inaccessible, with 89.1% of the respondents who have the needs for such surgeries unable to pursue them. On December 1, 2022, the Chinese National Medical Products Administration banned online sales of cyproterone acetate, estradiol, and testosterone, which are the most common hormones and antiandrogens used in transgender hormone replacement therapy.
In April 2024, a report was published regarding two hunters from the same lodge who, in 2022, were found to be afflicted with sporadic CJD after eating deer meat infected with chronic wasting disease (CWD), suggesting a potential link between CWD and CJD.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Dry lyophilized powder is usually kept frozen, desiccated, and out of direct light. Sealed vials are not opened until needed, because moisture uptake can degrade short peptides. Longer archival storage is often done at lower temperatures than routine working stock.